MTW Battery Grip w/ FRAC | Wolverine

MTW Battery Grip w/ FRAC – this one for your replica

The Wolverine MTW Battery Grip is an external upgrade that powers your MTW platform using standard 3V 123 batteries. This airsoft battery grip replaces your standard grip and offers an integrated power solution with an on/off switch. By using two CR123 batteries, you get up to 1,500 mAh capacity, which is significantly more than a typical LiPo battery. The built-in boost circuit ensures consistent power delivery to your HPA system, while the included Fixed Rear Airline Connector (FRAC) simplifies your HPA line management.

Technical specifications

This grip features a black finish with textured surfaces for improved grip. The water-resistant design protects the electronics from moisture during skirmishes. The grip is set at a 15-degree angle for enhanced ergonomics. The housing accepts two CR123 batteries (not included) and connects via the existing JST connector on your MTW. The FRAC module comes with a 3.5 inch airline with integrated filter and quick-disconnect fitting.

Compatibility and application

This battery grip fits all MTW-Spec lower receivers, including standard MTW M4 and MTW-9 models. Installation is done with the standard grip screw – no modifications required. The FRAC installs at the sling plate position for easy airline access. This upgrade is suitable for players who want to simplify their battery management while optimising their airline routing. Basic knowledge of MTW assembly is sufficient for installation.

Ready to add the MTW Battery Grip w/ FRAC to your setup?