X Gate USB type A cable for GATE mosfets

Gate USB Type A Cable for GATE MOSFETs – essential for your replica

This USB Type A cable is designed for programming and configuring GATE MOSFETs via the USB Link module. If you are using a GATE MOSFET in your AEG, you need this cable to adjust settings, perform firmware updates, or run diagnostics. The MOSFET accessory connects your computer directly to your MOSFET for full control over your trigger response, burst modes, and other advanced features.

Technical specifications

The cable features a flat wire design with low-resistance wiring for stable data transfer. The black cable measures 4'1" (approximately 125 cm) and provides ample freedom of movement during programming. The USB Type A connector fits any standard USB port on your computer or laptop.

Compatibility and application

This cable works exclusively with the GATE USB Link module and is compatible with all GATE MOSFET models that support USB programming. You connect the cable between your computer and the USB Link attached to your MOSFET. No assembly experience is required – it is plug-and-play once you have installed the GATE software.

Ready to add the Gate USB Type A Cable for GATE MOSFETs to your setup?